欢迎您访问青岛亿金来钢膜结构安装修缮工程有限公司 网站!

青岛亿金来钢膜结构

承接各停放,景观 体育看台等膜结构棚

青岛亿金来钢膜结构安装修缮工程有限公司
统一咨询电话:15694496888
当前位置:首页>新闻中心-技术知识-充电桩车棚的安装步骤及其注意事项
充电桩车棚的安装步骤及其注意事项
来源:http://www.sdcscp.com/ 发布时间:2022-09-15
膜结构充电桩车棚的安装可以使充电桩避免了日晒雨淋,延长了它的使用寿命,另外膜结构停车棚还能为人们带来便利,瓢泼大雨、烈日暴晒时,雨棚恰好为车子提供了一处临时安身之所。今天,小编就为大家介绍一下充电桩车棚的安装步骤及其注意事项。
The installation of the membrane structure charging pile shed can prevent the charging pile from being exposed to the sun and rain, and extend its service life. In addition, the membrane structure parking shed can also bring convenience to people. When it rains heavily and is exposed to the sun, the canopy just provides a temporary shelter for the car. Today, I will introduce the installation steps and precautions of the charging pile shed.
安装步骤:
Installation steps:
1、膜结构安装时,应在膜面上安设爬用安全网,作业人员须系安全带。在安装过程中,作业人员在膜面上行走应穿软底鞋,不应佩挂钥匙等硬物。
1. When installing the membrane structure, the climbing safety net shall be installed on the membrane surface, and the operators must wear safety belts. During installation, operators shall wear soft soled shoes when walking on the membrane surface, and shall not wear hard objects such as keys.
2、膜结构的安装宜在风力不大于四级的情况下进行。在安装过程中应充分注意风速和风向,避免发生颤动现象。同时应根据降雨的程度决定工程的中止和继续。
2. The installation of membrane structure should be carried out when the wind force is not greater than Grade IV. Pay full attention to the wind speed and direction during installation to avoid flutter. At the same time, the suspension and continuation of the project shall be determined according to the degree of rainfall.
3、张拉时应确定分批张拉顺序、量值,控制张拉的速度,并根据材料的特性确定超张拉量值。
3. During tensioning, the tensioning sequence and quantity shall be determined in batches, the tensioning speed shall be controlled, and the over tensioning quantity shall be determined according to the characteristics of materials.
4、当下道工序或相邻工程开始施工时,对膜结构已完成部分须采取保护措施,防止损坏。
4. When the next process or adjacent works start construction, protective measures must be taken for the completed part of the membrane structure to prevent damage.
5、膜体辅设过程中须做好成品保护,不应损坏膜面。膜面支承结构之间须设隔离层,不得直接接触。
5. The finished products must be well protected during the auxiliary installation of the membrane body, and the membrane surface shall not be damaged. Isolation layer shall be set between membrane supporting structures, and direct contact is not allowed.
6、膜结构的脊索、谷索其锚头的组装须严格按膜结构车棚厂的工艺标准执行,脊索、谷索应张拉到位。对有控制要求的张力值应作施工记录,对无控制要求的应作张拉行程记录。
6. The assembly of the anchor head of the ridge cable and valley cable of the membrane structure must strictly comply with the process standards of the membrane structure shed factory, and the ridge cable and valley cable should be tensioned in place. The tension value with control requirements shall be recorded for construction, and the tensioning stroke without control requirements shall be recorded.
7、膜结构脊索、谷索的安装应按施工组织设计要求进行。在膜结构安装过程中在脊索、谷索安装之前宜采用临时脊、谷压绳。以防止未完工膜结构在风载下产生过大晃动。
7. The installation of ridge cable and valley cable of membrane structure shall be carried out according to the requirements of construction organization design. During the installation of membrane structures, temporary ridge and valley pressing ropes should be used before the installation of ridge and valley cables. To prevent the unfinished membrane structure from excessive shaking under wind load.
膜结构充电桩车棚
注意事项:
matters needing attention:
1、膜结构充电桩车棚在建造前要进行实地考察,不仅要考虑停车方便,还得考虑施工方面的因素,综合自然环境风力雨雪的影响,尽量选择避开风口施工难度小的位置。
1. Before the construction of the membrane structure charging pile shed, the field investigation shall be carried out. Not only the convenience of parking, but also the factors of construction shall be considered. Considering the impact of wind, rain and snow in the natural environment, the location with less difficulty in construction shall be selected as far as possible to avoid the tuyere.
2、根据实地考察结果,设计合理的结构图。膜结构充电桩车棚的设计非常重要,既要考虑充电桩的大小尺寸又得考虑环境天气,如果风大雨雪大的地方尽量使用带帽顶结构的设施,这样可以充分缓解风雪的阻力和积雪融化后的处理。在风力小或者有折风墙的地方可以用直挑或者七字型膜结构车棚,这样可以节省工程成本缩短施工工期。
2. According to the results of field investigation, a reasonable structure diagram is designed. The design of the membrane structure charging pile shed is very important. Both the size of the charging pile and the environmental weather should be considered. If the wind, rain and snow are heavy, try to use the facilities with a cap structure, which can fully alleviate the resistance of wind and snow and the treatment after snow melting. In places with low wind force or wind break walls, we can use straight cantilever or seven shaped membrane structure shed, which can save project cost and shorten construction period.
3、膜结构充电桩车棚膜材的选择尽量用进口自洁性高的膜材。因为充电桩是耐耗工程这就要求膜结构充电桩停车棚使用寿命要持久,进口膜材可以提高整体使用寿命,并且拉力大抗风性高,非常的符合要求。
3. The membrane materials for the vehicle shed of the membrane structure charging pile shall be imported membrane materials with high self-cleaning property. Because the charging pile is a wear resistant project, it requires that the service life of the membrane structure charging pile parking shed should be long. Imported membrane materials can improve the overall service life, and the tension is large and the wind resistance is high, which is very consistent with the requirements.
建议,建造膜结构充电桩车棚要选择经验资质齐全的膜结构公司。因为有实际经验,所以在图纸的设计阶段及车棚施工中对结构的细节处理,会非常的到位。更多相关内容就来我们网站http://www.sdcscp.com咨询吧。
It is suggested that membrane structure companies with complete experience and qualifications should be selected for the construction of membrane structure charging pile shed. Because of practical experience, the details of the structure will be handled in place during the design stage of the drawings and the construction of the shed. More relevant content will come to our website http://www.sdcscp.com Consult.
图标分类中心

Product

联系我们
青岛亿金来钢膜结构安装修缮工程有限公司 青岛亿金来钢膜结构安装修缮工程有限公司

联系电话:15694496888

联系地址:山东省青岛市城阳区前海西社区居委会西100米