欢迎访问山东程顺彩蓬厂网站!

当前位置:首页-新闻中心-行业资讯-济南推拉篷膜面破损的四个修补要点

济南推拉篷膜面破损的四个修补要点

来源:http://www.sdcscp.com/ 日期:2020-11-13 发布人:admin

在安装和使用过程中,济南伸缩篷可能由于各种原因而损坏或损坏,膜面处理过程中焊接缺失或焊缝脱落等;
In the process of installation and use, the Jinan telescopic canopy may be damaged or damaged due to various reasons, and the welding seam is missing or falling off in the process of film surface treatment;
安装过程中被地面或其他结构物拖曳而造成的磨损,锋利物品划伤或刺穿,吊装或张拉时意外撕裂;
Abrasion caused by dragging by the ground or other structures during installation, scratching or piercing of sharp objects, and accidental tearing during hoisting or tensioning;
在使用过程中,坠落物破碎或人为损坏。一旦出现这种情况,就需要及时修复。根据膜表面损伤的具体情况,
In the process of use, falling objects are broken or damaged artificially. Once this happens, it needs to be repaired in time. According to the specific situation of membrane surface damage,
济南推拉篷膜面破损的四个修补要点
Four repair points for membrane surface damage of Jinan push pull awning
济南推拉篷的维修工作可分为以下几种方式:
The maintenance work of Jinan sliding canopy can be divided into the following ways:
1)仅在膜结构局部涂层磨损,基布纤维完好无损时,可使用高性能透明胶在磨损区域粘贴或热封。
1) High performance transparent adhesive can be used to paste or heat seal the worn area only when the local coating of the membrane structure is worn and the base cloth fiber is intact.

2)膜表面损伤面积小于50mm时,剪下椭圆形或圆形膜布,焊接在膜结构损伤区域,作为加固层。
2) When the damage area of membrane surface is less than 50 mm, the elliptical or circular membrane cloth is cut and welded in the damaged area of membrane structure as the reinforcement layer.
3)如果膜表面的损伤范围超过50毫米,但小于300毫米,准备一个薄膜带长度和宽度大于150毫米范围内的损害,强化层,焊接在膜表面的膜结构损伤区域。
3) If the damage range of the membrane surface is more than 50 mm but less than 300 mm, prepare a damage within the range of 150 mm in length and width of the film strip, strengthen the layer, and weld the membrane structure damage area on the membrane surface.
4)膜表面损坏部分超过300mm
4) The damaged part of membrane surface is more than 300 mm
损坏的部件应拆卸并运回工厂维修或更换。在1)- 3)以上情况下,修复方法取决于所使用的膜材料类型。涂覆PVC涂层的济南伸缩篷材料可通过热风风机进行修补;待修复区域应清除并平放,和补丁应当被放置在表面焊接,和PVC涂层表面的膜材料由热空气融化,然后是补丁和下电影由小辊紧密相连的。
Damaged parts should be removed and returned to the factory for repair or replacement. Above 1) - 3), the repair method depends on the type of membrane material used. The material of Jinan telescopic canopy coated with PVC coating can be repaired by hot air fan; the area to be repaired shall be removed and laid flat, and the patch shall be placed on the surface for welding, and the membrane material on the surface of PVC coating shall be melted by hot air, and then the patch and the lower film shall be closely connected by small rollers.
相关推荐

山东程顺彩蓬厂

皖公网安备 34122502000554号

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】